Cutting Aspect Metal Tiles

Note that it is not necessary to cut through the tile but to score it deeply with the knife.

Cutting aspect metal tiles.

To successfully cut your self adhesive tiles you need to know the exact size of the piece that you need. Map out and mark the cut using masking tape to cover the surface of the tile. But i found it much easier to use an oscillating tool to cut it with better accuracy. You should leave approximately a inch gap away from the wall.

This shows you how to cut them with minimal eff. I placed a board inter the tile and started by putting the. Use tube adhesive for cut pieces of aspect that are less than a third of a full tile. The representative from aspect that i spoke with suggested a 60 80 tooth blade that can cut through steel if you go the route of using a miter saw but they highly recommended using tin snips.

To fit partial tiles lay the tile to be cut exactly over the last full tile. Cut tile on line. But i decided to pick up a new set of quality tin snips. Bend the tile in half.

Every backsplash installation starts with a dry layout. Be sure to protect your eyes from damage by using protective eyewear or safety goggles. When installing the aspect metal peel and stick backsplash tiles it will be required to cut them eventually. Page 3 of the aspect metal peel stick tile installation guide lists the recommended tools to cut the tiles.

Take the cut tile to the work space and place it in its intended location ensuring it fits properly. Cut the tile using the recommended cutting tools figure 9. Cut and install all remaining tiles using the same steps described above. Tips on cutting installing metal tile backsplash layout.

Place another full tile against the wall and mark the cutting line where the tiles overlap. Best wishes on your project and please be sure to share a photo with us. This may mean a carbide blade or a diamond blade specifically. Page 5 has action photos for measuring and cutting the tiles.

Use your tape measure to get the exact dimensions of the gap. Cut all metal tiles with a blade meant for metal. When you get to the edge of a room you will have a gap that needs to be covered with a partial self adhesive tile. This layout helps determine the pattern to install the.

Aspect says to use tin snips to cut their tiles. Find answers to frequently asked questions about aspect peel and stick tiles in metal stone glass and wood.