Then use two clamps to hold the leg extension and housing at the correct length.
Diy table saw extension wing.
Parallel jaw clamps work great for this.
The extension installs easily.
Where the extension will meet the table saw drill 3 holes that into the extension to match the 3 holes in the table saw using the 3 16 inch drill bit.
If your saw has one add the extension table and level it with the top.
Making a frame for this could have been a lot easier.
Drill a 3 16 inch hole and connect the leg to the extension with a 3 16 inch bolt and a washer and wing nut.
See more ideas about table saw table saw extension woodworking.
With the factory extension wing removed from the table saw i can transfer the mounting locations to the new extension wing.
All you need is some scrap wood and a handful of inexpensive casters.
And drill the holes.
Make a handy outfeed support that adjusts to fit your table saw band saw planer or router.
To save bending down assemble the extension table support legs and frame on your saw s tabletop.
The extension table stores on the wall.
The wing is attached to the saw with 3 bolts and to the rails with one bolt on front and back.
Swiveling casters will roll in any direction so you can use the support on either side of the table saw or other tool.
Mark and trim the bottom corners of the leg extension so it nests completely against the leg stop.
Its front and back rails capture the saw bracket to minimize movement.
The rules are calibrated so the fence is parallel to the blade when both measurements match.
A 17mm socket is needed for the saw bolts and a 13mm socket for the rails.
I was actually able to use mounting holes that were much further away from the table saw than the previous wing which helped to evenly distribute the weight of the wing.
Adjust and reclamp the leg parts as needed until the outfeed table is flush with the saw table.
Repeat for both leg extensions.
Feb 15 2018 explore richard castro s board table saw extension on pinterest.