Door Frame Installation Tolerances

2 measure the sides of the door frame.

Door frame installation tolerances.

Weight or force shall be 2. Linear dimensions shall be 1 16 in. 8 frame installation and door adjustments 8 1 adjusting pivot point by shimming providing extra depth along door or frame faces allows for hinge knuckles to be offset thus changing the pivot point of the opening. What are the installation tolerances for hollow metal frames.

Keep in mind that if the door has 2x4 walls then the frame will be 4 1 2 11 4 cm. Width of doorsets 2 0 mm. The standard provides the following tolerances for internal doorsets leaves and frames. Height of door leaf 1 5 mm.

At least it is some type of printed guideline. Frame installation and door adjustments. Commonly specified from the floor bottom of frame to centerline c l of cutout in edge of door or centerline c l of strike in new installation. Check the nahb residential construction performance guide 9 1 6 when the contractor installs the door frame and door the door edge shall be within 3 16 inch of parallel to the door jamb.

In door faces shall have similar tolerances. Width of door leaf 1 5 mm. If the door has 2x6 walls then the frame will always be 6 1 2 16 5 cm. Height of doorset 2 0 mm.

It is also intended to provide installation contractor s of the tolerances to be considered to assure proper operation of the complete opening. Door leaf thickness over 1 0 mm 2 0 mm. If frames are installed not in compliance with either standard one or more of the following issues may occur. Sdi 110 2009 standard steel doors and frames for modular masonry construction sdi 111 2009 recommended standard details for steel doors frames accessories and re lated components sdi 122 2007 installation and troubleshooting guide for standard steel doors and frames sdi 127d 2006 electric strikes in stud walls 31 metrication.

The recommended measurement for replacement doors is from the top of the door to the top of the cutout in edge of door if applicable or top of door to centerline c l of latch actuating hole i e top to top. It is the intent of this publication to provide users of standard steel doors and frames with definitive information regarding manufacturing tolerances. Shims are usually thin strips of 1 4 wide material approximately equal to the hinge height. Tolerances all values which do not carry specific tolerances or are not marked maximum or minimum shall have the following tolerances.

The guide to standards and tolerances was produced in collaboration with the victorian. It is the installing contractor s responsibility to install frames in accordance with either standard.